Payment & Shipping Terms:
|Usage:||Drawing And Annealing||Inlet Diameter:||3.0mm-3.5mm|
|Outlet Diameter:||1.0mm-2.8mm||Main Motor:||45KW|
|Max Line Speed:||1000mpm||Power Source:||380V/50-60Hz|
|After-sale Service:||Engineer Available To Overseas||Product Name:||Intermediate Wire Drawing Machine|
HXE-9DT Large-intermediate copper wire drawing machine with annealer
1. Pay-off shelf
2. HXE-13DT Copper wire drawing machine
3. HXE-TH350 Annealing machine
4. HXE-180 Tension controller
5. HXE-SX630 Double spooler
7. Operation panel
8. Drawing control cabinet
9. Annealing control cabinet
Large-intermediate copper wire drawing machine with annealer is used to drawing and annealing single bare copper wire from 3.0mm-3.5mm to 1.0mm-2.8mm
II. Main technical parameters
|Control system||Traditional analog type/digital control with production record|
|Frame||Welded by steel plate|
|Max capstan diameter||280mm|
|Fix speed capstan diameter||280mm|
|Spooler bobbin size||400-630mm|
|Bobbin loading&unloading type||Double end thimbles|
|Annealing method||DC.Three-section annealing|
|Cooling water capacity||650L/min|
|Compressed air capacity||0.4~0.6Mpa,50L/min|
|Power source||380V 50/60HZ|
III. Working environment
3-1. Altitude less than 1000m.
3-3. Relative temperature less than 85% (25℃)
3-4. Power source 380V, 50Hz, can be customized
3-5. Air capacity 18kg/h
IV. Machine structure
Annealing method is DC Three section annealing, there are three contact capstans, as Pre-Heating, Annealing and Drying. For drawing machine part, there is belts that connection from the Fix-speed capstan to the Annealer machine to achieve the transmission, as keep same speed.
Connect the Up capstan and Down capstan with Positive and Negative power, to make the wire in a short circuit, to achieve the heating.
There is annealing plate to auto track and adjust the speed and annealing voltage.
To achieve fast coolant to make the wire soft(Annealing), the Down capstan is immersed into the coolant water(There is a water tank in the bottom of the Annealer machine), coolant water is 0.5% emulsion.
With the Pump to pump the coolant water through all pipes and valves, half sealed annealing door. Adjust the valves to adjust the coolant water in certain height.
To make sure the wire no oxidation, in the annealing protection pipe has steam (Buyer self will prepare Steam generator).
In the drying section, has a blowing device (Require two Tungsten dies, Buyer self prepare, Die size D*1.04), by compressed air (Buyer self prepare Air compressor) to blow the water on the surface of the wire.